Weider 16.8ST - Manual (Page 7)

4. Place two Weight Bumpers (19) over the indicated
holes in the Stabilizer (5).
Insert the two Weight Guides (23) into the Weight
Bumpers (19) and the Stabilizer (5).
Attach the indicated Weight Guide (23) to the
Stabilizer (5) with a 3/8Ó x 2 1/2Ó Bolt (54), two 3/8Ó
Flat Washers (55), two 5/8Ó x 1/2Ó Pulley Bushings
(42), and a 3/8Ó Nylon Jam Nut (63).
4
23
19
55
5
19
63
55
42
42
54
5. See the inset drawing. Open the parts bag labeled
ÒWeight InsertsÓ. Press two Weight Inserts (77) into
the indicated holes in each Weight (26). Make sure
the large pin groove is oriented as shown.
Slide all nineteen Weights (26) onto the Weight
Guides (23). Make sure the Weights are oriented
correctly. The holes must be on the side shown.
Slide the Top Weight (16) and the Weight Tube (36)
onto the Weight Guides (23). Insert the Weight Tube
into the Weights (26).
Slide the welded tubes on the Top Frame (1) over the
upper ends of the Weight Guides (23). Align the
bracket on the Top Frame with the indicated holes in
the Main Upright (3). Insert two 3/8Ó x 3Ó Bolts (45)
into the holes. Thread a 3/8Ó Nylon Locknut (50) onto
the lower Bolt. Do not thread a Locknut onto the
upper Bolt yet.
Attach the Weight Guides (23) to the Top Frame (1)
with two 3/8Ó x 1 3/4Ó Bolts (60) and two 3/8Ó Nylon
Locknuts (50).
Press two 2Ó Square Inner Caps (33) into the Press
Frame (12).
5 45 33
1
60
50
50
23
16
36
26
Welded
Tubes
Bracket
Holes
3
12
77
26
Large Pin
Groove
7
6. Slide the Leg Press Base (84) onto the 3/8Ó x 3 3/4Ó
Carriage Bolt (52) and the 3/8Ó x 5Ó Carriage Bolt (82)
in the end of the Stabilizer (5). Tighten a 3/8Ó Nylon
Locknut (50) onto the 3/8Ó x 3 3/4Ó Carriage Bolt. Do
not place a Nylon Locknut on the 3/8Ó x 5Ó
Carriage Bolt yet. 6
84
82
52
50
5