ZyXEL Communications PES-1014 - Manual (Page 26)

PES-1014 User’s Guide
3-6 Getting Started
3.4.4 Saving Changes
If you do not save your configuration changes to flash memory, all of your changes will be lost when the switch is
restarted. Use the following steps to save changes when you are done configuring a screen.
Step 1. Click Apply (this saves the settings to working memory).
Step 2. Move your cursor over System in the Information Panel and click Save Changes.
Step 3. Click Save in the Save Changes screen (saves the settings to flash memory).
•
Settings in the Networking screen will not take effect until the switch is restarted. Do the following to restart:
Step 4. Move your cursor over Reset in the Information Panel and click Reboot Device.
Step 5. Click Reboot and Saving.
3.4.5 Reset
Click Reset to go to the screen’s previous configuration.