ZyXEL Communications PES-1014 - Manual (Page 38)

PES-1014 User’s Guide
5-4 Port
FIELD DESCRIPTION EXAMPLE
security parameters. A security violation is defined as any incoming
packet that does not match a SA (Source MAC Address) on the address
table. When Disable is selected, the SA of incoming packets is not
checked.
Address Learning Select Enable to enable or Disable to disable dynamic MAC address
learning. Disable
(default)
Full Duplex Flow
Control (802.3x) Select Enable to enable or Disable to disable 802.3x Full Duplex Flow
control. Enable
(default)
Auto Negotiation
(Ethernet ports
only) When you select Enable the port automatically negotiates the
transmission rate and duplex mode.
When you select Disable auto negotiation is turned off and you need to
specify the transmission rate and duplex mode manually.
Enable
(default)
Speed/Duplex
(Ethernet ports
only) Select the data transmission rate and duplex mode of the selected port
(see Table 5-2).
To enable the forcing mode operation, you must disable auto-negotiation.
100 Full
(default)
Broadcast Storm
Control Select Enable to turn on Broadcast Storm Control. This discards
consecutive incoming broadcast packets that exceed the programmed
threshold (set in the system configuration screen).
Select Disable to cancel Broadcast Storm Control.
Enable
(default)
Click Apply to save your changes to working memory or click Reset to go to the previous configuration. Refer
to 3.4.4 for directions on saving your changes to flash memory before you restart the switch.
5.4 Port Assigned
Move the cursor over the Port link and then click Port Assigned to display the Port Assigned screen shown next.
Use the Port Assigned screen to copy a selected port’s settings to other ports.
The Auto Negotiation and Speed/Duplex choices apply only to Ethernet ports.