ZyXEL Communications PES-1014 - Manual (Page 33)

PES-1014 User’s Guide
System 4-7
FIELD DESCRIPTION EXAMPLE
characters.
Access
Right Select Read-Only, to allow the management host to perform read functions only.
Select Read-Write, to allow the management host to perform both read and
write functions. Read-Write
(default)
Trap
Receiving Select Enable to allow the management host to receive SNMP Traps.
Select Disable to disallow the management host from receiving SNMP Traps. Enable
(default)
Status Select Enable or Disable to enable or disable a specific community. Enable
(default)
Click Apply to save your changes to working memory or click Reset to go to the previous configuration. Refer
to 3.4.4 for directions on saving your changes to flash memory before you restart the switch.
You must get a valid Community string before enabling the specified Community.
4.6.2 SNMP Host
This SNMP Host screen gives SNMP host information. The maximum number of SNMP hosts is six.
Figure 4-7 SNMP Host
Table 4-6 SNMP Host Description
FIELD DESCRIPTION EXAMPLE
IP Address Input the IP addresses of the management hosts so they
can receive SNMP trap messages. 192.168.10.2
(default)
Host Name This column indicates the name of the management host. It
is case sensitive and its maximum length is 12 characters. Factory SnmpM
(default)
Community Indicates the name of the community that the management
host belongs to. See the previous figure or the top half of
the screen. public
(default)
Status Select either Enable or Disable to enable or disable the
SNMP management functions of each management host. Enable
(default)
Click Apply to save your changes to working memory or click Reset to go to the previous configuration. Refer to
3.4.4 for directions on saving your changes to flash memory before you restart the switch.