ZyXEL Communications P-202 User Manual
Page 172
P-202H Plus v2 Support Notes
in section 2.1. If you prefer to use commands from console, please go to section
2.2.
2.1 Setup Ciscro by ConfigMaker
You can download Cisco ConfigMaker from
.
1. Select AutoDetect device Wizard in Devices window.
2. Make sure that the console has been connected to your PC. If the router is
detected successfully, a Cisco router should appear in the Network
Diagram Window.
3. Click right button of the mouse, choose Device Properties.... In
Passwords tab, setup the passwords for this router.
See the screen shot:
4. From Devices window choose a router, and add this router in Network
Diagram. Rename it as "P-202H Plus v2". Assign passwords, choose
TCP/IP as it's protocol, and then set the interface of WAN slot 0 as 1
Ethernet.
All contents copyright © 2006 ZyXEL Communications Corporation.
172