General application notes, Internet access – ZyXEL Communications P-202 User Manual
Page 36
P-202H Plus v2 Support Notes
General Application Notes
1. Internet Access
A typical Internet access application of the P-202H Plus v2 is shown below. For a
small office, there are some components you need to check before accessing the
Internet.
•
Before you begin
The P-202H Plus v2 is shipped with the following factory default:
1. IP address = 192.168.1.1, subnet mask = 255.255.255.0 (24 bits)
2. DHCP server enabled with IP pool starting from 192.168.1.33
3. Default SMT menu password = 1234
•
Setting up the Win95/98 Workstation
1. Ethernet connection
All PCs must have an Ethernet adapter card installed.
•
If you only have one PC, connect the PC's Ethernet adapter to the P-202H
Plus v2's LAN port with a crossover (red one) Ethernet cable.
•
If you have more than one PC, both the PC's Ethernet adapters and the P-
202H Plus v2's LAN port must be connected to an external hub with
straight Ethernet cable.
2. TCP/IP Installation
You must first install TCP/IP software on each PC before you can use it for
Internet access. If you have already installed TCP/IP, go to the next section to
configure it; otherwise, follow these steps to install:
•
In the Control Panel/Network window, click Add button.
•
In the Select Network Component Type windows, select Protocol and
click Add.
•
In the Select Network Protocol windows, select Microsoft from the
manufacturers, then select TCP/IP from the Network Protocols and click
OK.
3. TCP/IP Configuration
Follow these steps to configure Windows TCP/IP:
All contents copyright © 2006 ZyXEL Communications Corporation.
36