Xerox 96MX - Manual (Page 196)

PRINT FORMAT COMMANDS
6-22 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
POSITION
This parameter specifies the initial character position of the CME in
the print line.
Syntax ac:CME POSITION = option(s)
Options Table 6-17 lists the parameter option(s) and definition(s).
Points to note
Note the following when using the CME command:
• The CME LINE and POSITION parameters are order
dependent in that LINE must always precede POSITION.
•
Data lines
Data lines are not properly aligned if proportional fonts are
being used in landscape mode and a switch is made to a larger
font in the middle of the line. This restriction is a result of the
functioning of the printer imaging hardware.
• Multiple copies
If a multicopy is aborted before all the pages are set up in the
page log, one copy gets printed if the CMEs are copy-sensitive.
Otherwise, all copies of the setup pages are printed.
•
OVERPRINT, FONTINDEX, and CMEs
CMEs are not applied if OVERPRINT=MERGE and
FONTINDEX are both specified.
CME parameters are applied to all lines within the range
regardless of whether or not variable data appears on those
lines.
Table 6-17. POSITION parameter option(s) and definition(s)
Option(s) Definition(s)
n An integer value between 1 (the first position of the
print line) and the value specified by the length right-
part of the DATA= parameter in the LINE command.
The default is 1.