Xerox 96MX - Manual (Page 292)

USING LOGICAL PROCESSING
7-12 XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS PDL REFERENCE
Masked comparisons using non-default type assignments
Performing masked comparisons using either a nonstandard
character set or a standard set for which the default type
assignments are not suitable requires coding the following:
•
TCODE command. This command is used either to modify a
set of standard default type assignments or to define a
completely new set (refer to processing sequence 3 in figure
7-1). Refer to the “Character type assignments” section in
chapter “Specifying input parameters,” for detailed information
on the TCODE command.
• TCODE parameter of the VOLUME command. This
parameter is used to specify the set of assignments defined by
the TCODE command as the one used for masked comparison.
•
The MASK and CONSTANT parameters of one or more
occurrences of the TABLE command. The use of these
parameters is the same as for comparisons using unmodified
defaults.
Figure 7-1. String comparison parameters