Setting copy collation before copying a document – Xerox 450c User Manual
Page 203
Advertising
203
Setting copy collation before
copying a document
By default, the WorkCentre does not collate multiple
copies. You can change the default setting at the control
panel to have the WorkCentre always collate multiple
copies.
Note The WorkCentre stores the document to
memory before printing the collated copies. If the
WorkCentre’s memory runs low, it will not collate the
copies.
1. At the WorkCentre 450c, press
MENU
.
2. Press 5 [Setup] and
ENTER
.
3. Press 7 [Control panel] and
ENTER
.
4. Press 7 [Collate copies] and
ENTER
.
5. Press
RIGHT ARROW
to display [yes] and
ENTER
.
6. Press
STOP
to exit the menus.
The WorkCentre is set to collate multiple copies of the
same document. To copy a document, see the previous
section, “Copying a document.
Advertising