XiNCOM Twin WAN XC-DPG402 - Manual (Page 17)

XiNCOM Corp.
• The
Error LED will flash during start up, but will then turn Off. If it stays On, there is an error
condition.
• For each PC connected to the LAN ports, the corresponding LAN LED (either 10 or 100)
should be ON.
3. Configuring the XC-DPG Twin WAN Router for Internet Access
Select Primary Setup from the menu, to see a screen like the example below.
• Configure WAN 1 and/or WAN 2 as required.
• For any of the following situations, refer to Chapter 3: Advanced Port Setup for any further
configuration which may be required.
• Using
both ports
• Multiple IP addresses on either port
• Multiple PPPoE sessions
• PPTP connection method
Figure 8: Primary Setup Screen
Page 15