Settings – primary setup – XiNCOM Twin WAN XC-DPG402 User Manual

Page 18

Advertising
background image

Settings – Primary Setup

Connection
Mode

Select the appropriate setting:

Enable – Select this if you have connected a broadband modem to this

port.

Disable – Select this if there is no broadband modem connected to this

port.

Backup – Use this if you have a broadband modem on each port, and wish

to normally use only one. Select Enable for the primary port, and Backup
for the secondary port. The Backup port will only be used if the primary port
fails.

Connection
Type

Check the data supplied by your ISP, and select the appropriate option.

Static IP – Select this if your ISP has provided a Fixed or Static IP

address. Then enter the data into the Address Info fields.

Dynamic IP – Select this if your ISP provides an IP address automatically,

when you connect. You can ignore the Address Info fields.

PPPoE – Select this if your ISP uses this method. (Usually, your ISP will

provide some PPPoE software. This software is no longer required, and
should not be used.)
If this method is selected, you must complete the PPPoE dialup fields.

Note:

If using the PPTP connection method, select Static IP or Dynamic IP, as
appropriate; according to the IP address method used by your ISP.

Address Info

This is for Static IP users only. Enter the address information provided by your
ISP. If your ISP provided multiple IP address, you can use the Multi-DMZ
screen to assign the additional IP addresses.

PPPoE / PPTP
Dialup

This is for PPPoE and PPTP users only.

• Enter

the

Username and Password provided by your ISP.

• If using PPTP, enable the PPTP Connection checkbox, and enter the IP

address of the PPTP server.

• Host name (Optional for PPPoE), this field is used by a Host to uniquely

associate an access concentrator to a particular Host request.

Note:

There are additional PPPoE/PPTP options on the Port Options screen.

To use multiple PPPoE sessions on either port, configure the Advanced
PPPoE
screen.

DNS

If using a Fixed IP address, you MUST enter at least 1 DNS address.
If using Dynamic IP or PPPoE, DNS information is optional.

Page 16

Advertising
This manual is related to the following products: