XiNCOM Twin WAN XC-DPG402 - Manual (Page 5)

XiNCOM Corp.
All trademarks and trade names are the properties of their respective owners.
1: Introduction
Congratulations on the purchase of your new Twin WAN Router. The Twin WAN Router provides you
with shared internet across the entire LAN along with Load Balancing and Automatic Failover
features.
This is the most typical network setup where the router is used to accommodate.
Figure 1: XC-DPG Twin WAN Router (502 Shown)
Twin WAN Router Features
• 2 x 10/100 WAN (Wide Area Network) Ports: The XC-DPG502 incorporates 2-port 10/100
WAN ports, complete with auto-crossover for easy connection to an existing network. All
popular DSL and Cable Modems and connection methods are supported, including Fixed IP,
Dynamic IP, PPPoE, even multiple-session PPPoE.
• 4 x 10/100 LAN (Local Area Network) Ports: The XC-DPG502incorporates a 4-port 10/100
N-Way Ethernet Switch, complete with auto-crossover for easy connection to an existing
network.
• VPN Security: Full VPN Endpoint with support for up to 100 VPN tunnels using the PPTP
and IPsec encryption protocol.
• Load Balancing: Allows you to use both WAN ports simultaneously, increasing your
available bandwidth. You can set load balance type by Packets, Bytes RX+TX and Sessions.
Load balancing is session based
Page 3