Using chipscope with opb iic – Xilinx ML403 User Manual
Page 18
Using ChipScope with OPB IIC
XAPP979 (v1.0) February 26, 2007
18
R
Using
ChipScope with
OPB IIC
To facilitate the use of ChipScope to analyze OPB IIC hardware, the
iic.cdc
file is included in
the
ml403_ppc_opb_iic/chipscope
directory. The
iic.cdc
is used to insert a
ChipScope ILA core into the opb_iic core. The following steps are used to insert a core and
analyze OPB IIC problems with ChipScope.
1. Invoke XPS. Run Hardware
→
Generate Netlist.
2. In the
iic.cdc
file, change the path
<design_directory>
name to the directory in which
the design files are installed. Three paths need to be changed.
3. Run Start
→
Programs
→
ChipScope Pro
→
ChipScope Inserter
4. From ChipScope Inserter, run File
→
Open Project ii.cdc.
shows the ChipScope
Inserter setup GUI.
Figure 22: ChipScope Inserter Setup
X979_22_012907