ZyXEL Communications NWA3160 - Manual (Page 204)

Chapter 17 Log Screens
ZyXEL NWA-3160 Series User’s Guide
204
17.4 Log Commands
Go to the command interpreter interface (the Command Interpreter appendix explains how to access and
use the commands).
17.4.1 Configuring What You Want the ZyXEL Device to Log
Use the sys logs load command to load the log setting buffer that allows you to configure which logs
the ZyXEL Device is to record.
Use sys logs category followed by a log category and a parameter to decide what to record
Use the sys logs save command to store the settings in the ZyXEL Device (you must do this in order
to record logs).
17.4.2 Displaying Logs
Use the sys logs display command to show all of the logs in the ZyXEL Device’s log.
Use the sys logs category display command to show the log settings for all of the log categories.
Use the sys logs display [log category] command to show the logs in an individual ZyXEL
Device log category.
Use the sys logs clear command to erase all of the ZyXEL Device’s logs.
16 Information Reply
0 Information reply message
Table 82 Sys log
LOG MESSAGE DESCRIPTION
Mon dd hr:mm:ss hostname
src="<srcIP:srcPort>"
dst="<dstIP:dstPort>"
msg="<msg>" note="<note>" This message is sent by the "RAS" when this syslog is
generated. The messages and notes are defined in this
appendix’s other charts.
Table 81 ICMP Notes (continued)
TYPE CODE DESCRIPTION
Table 83 Log Categories and Available Settings
LOG CATEGORIES AVAILABLE PARAMETERS
error 0, 1, 2, 3
mten 0, 1
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to record only
alerts for that category, and 3 to record both logs and alerts for that category.