Exit setup mode – Zebra ZM400 User Manual
Page 65
57
Configuration
Setup Mode
3/27/07
ZM400/ZM600 User Guide
79695L-001 Rev. A
Exit Setup Mode
To leave Setup mode, complete these steps:
1.
Press
SETUP/EXIT
.
The LCD displays
SAVE CHANGES
.
2.
Press
PLUS (+)
or
MINUS (-)
to display the save options:
3.
Press
SETUP/EXIT
to select the displayed choice.
When the configuration and calibration sequence is done,
PRINTER READY
displays.
LCD
Description
PERMANENT
Stores values in the printer even when power is turned off.
TEMPORARY
Saves the changes until power is turned off.
CANCEL
Cancels all changes made since you entered Setup mode,
except for changes made to the darkness and tear-off settings,
which go into effect as soon as they are made.
LOAD DEFAULTS
Restores all parameters other than the network settings back to
the factory defaults. Use care when loading defaults because
you will need to reload all settings that you changed manually.
Note •
Loading factory defaults causes the printer to
auto-calibrate.
LOAD LAST SAVE
Loads values from the last permanent save.
DEFAULT NET
Restores the wired and wireless network settings back to
factory defaults.