Zebra ZM400 - Manual (Page 80)

Configuration
Control Panel Parameters 72
79695L-001 Rev. A ZM400/ZM600 User Guide 3/27/07
ZPL and XML only Format Memory Card
This option erases all previously stored information from the optional
64 MB flash chip on the Wireless Plus option board. This parameter
appears only when a Wireless Plus option board with the flash chip
populated is installed.
Caution • This option completely erases the flash chip.
To format a memory card:
1. Press SELECT to select the parameter.
2. Press PLUS (+) to select
A:
.
If your printer is set to require a password, you are prompted to enter
the password.
3. Enter the password. For instructions, see Change Password-Protected
Parameters on page 58 .
4. Press the appropriate button again to select the desired card.
The display shows ARE YOU SURE? .
5. Do you want to continue?
• Press MINUS (-) to select
NO
to cancel the request and return to
FORMAT CARD prompt.
• Press PLUS (+) to select YES and begin initialization.
When initialization is complete, the control panel displays
FORMATTING CARD COMPLETED .
Note • Depending on the amount of memory in the memory card,
initialization may take up to 5 minutes to complete.
6. Press SELECT to deselect the parameter.
Table 12 • Printer Parameters (Page 11 of 24)
Parameter Action/Explanation