Zebra ZM400 User Manual

Page 43

Advertising
background image

35

Operations

Load Media

3/27/07

ZM400/ZM600 User Guide

79695L-001 Rev. A

4.

Feed the media under the dancer assembly (

1

), the upper media sensor (

2

), and the ribbon

sensor (

3

). Slide the media back until it touches the inside back wall of the upper media

sensor.

5.

Continue with the final instructions for the desired print mode. The print mode must be
compatible with the media being used and the printer options installed. See

Print Mode

Descriptions and Printer Requirements on page 30

for more information.

Additional Steps for Tear-Off Mode on page 36

Additional Steps for Peel-Off Mode (with or without Liner Take-Up) on page 37

Additional Steps for Cutter or Delayed Cut Mode on page 42

Additional Steps for Rewind Mode on page 43

e.

Slide in the media supply guide until
it touches the edge of the roll.

d.

Flip up the media supply guide.

e.

Slide in the media supply guide until
it touches the edge of the media.

Roll Media (Continued)

Fanfold Media (Continued)

1

3

2

Advertising
This manual is related to the following products: