Adjust printhead pressure – Zebra ZM400 User Manual

Page 61

Advertising
background image

53

Operations

Adjust Printhead Pressure

3/27/07

ZM400/ZM600 User Guide

79695L-001 Rev. A

Adjust Printhead Pressure

You may need to adjust printhead pressure if printing is too light on one side, if you use thick
media, or if the media drifts from side to side during printing.

See

Figure 10

. The ZM400 pressure adjustment dials have four possible settings designated by

blocks of increasing size embossed on the print mechanism. The smallest block (fully
counterclockwise) is considered position 1, and the largest block (fully clockwise) is
considered position 4. The ZM600 dials have seven settings instead of four.

Figure 10 • Printhead Pressure Adjustment Dials

To set printhead pressure, complete these steps:

1.

Use

Table 10

or

Table 11

to select the initial dial settings for your media, depending on

which printer you have.

1

Outside dial

2

Inside dial

1

2

Table 10 • ZM400 Printhead Pressure

Media Width

Inside Dial

Outside Dial

1 in. (25.4 mm)

3

1

2 in. (51 mm)

4

1

3 in. (76 mm)

3

2

3.5 in. and up (89 mm and up)

3

3

Advertising
This manual is related to the following products: