ZyXEL Communications ZyXEL Dimension GS-4012F - Manual (Page 261)

GS-4012F/4024 User’s Guide
260 Chapter 40 Introducing the Commands
40.9.4 interface port-channel Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
Table 96 interface port-channel Commands
COMMAND DESCRIPTION
interface
port-channel
<port-list>
Enables a port or a list of ports
for configuration.
bandwidth-limit Enables bandwidth control on
the port(s).
cir <Kbps> Sets the guaranteed bandwidth
allowed for incoming traffic on
the port(s).
egress <Kbps> Sets the maximum bandwidth
allowed for outgoing traffic on
the port(s).
ingress <Kbps> Sets the maximum bandwidth
allowed for incoming traffic on
the port(s).
pir <Kbps> Sets the maximum bandwidth
allowed for incoming traffic on
the port(s).
bpdu-control
<peer|tunnel|discard
|network>
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
broadcast-limit Enables broadcast storm
control limit on the switch.
diffserv Enables DiffServ on the port(s).
<pkt/s> Sets how many broadcast
packets the interface receives
per second.
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
<pkt/s> Sets the interface DLF limit in
packets per second (pps).
egress set <port-
list>
Sets the outgoing traffic port list
for a port-based VLAN.
exit Exits from the interface port-
channel command mode.
flow-control Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
frame-type
<all|tagged>
Choose to accept both tagged
and untagged incoming frames
or just tagged incoming frames
on a port.