ZyXEL Communications MES-2110 - Manual (Page 185)

Chapter 23 Command Line Interface
MES-2110 User’s Guide
185
show rstp
Displays the RSTP configuration.
show sfp ddmi port <port-number>
Displays the SFP fiber port DDMI information for
the specified port.
show sfp serial-no port <port-number>
Displays the SFP serial number for the specified
port.
show sfp vendor port <port-number>
Displays the SFP vendor name for the specified
port.
show snmp
Displays the snmp configuration.
show sntp
Displays the SNTP configurations.
show sntp-timezone
Displays a list of time zones and their GMT offset.
show storm-control
Displays the storm control configuration.
show syslog [<begin:end>]
Displays all syslog messages.
You can also specify a range of syslog messages.
begin
: Enter the first syslog message to display.
end
: Enter the last syslog message to display.
show syslog-config
Displays the syslog configuration.
show version
Displays the system version.
show vlan port-base
Displays the port-base VLAN.
show vlan stacking
Displays the VLAN stacking status.
show vlan tag-base management-VLAN
Displays the VLAN for the management switch.
show vlan tag-base vlan-id
Displays the tag-base VLAN ID.
show vlan tag-base port-info
Displays the tag-base port information.
show vlan tag-base vlan-table
Displays tag-base VLAN table.
show vlan type
Displays the VLAN type.
write memory
Saves the current configuration, including all
changes made since the last save, to flash.
Note: You must use this command to
permanently save any changes you
make while using the MES-2110
command line interface.
Table 78 Privileged Commands
COMMAND DESCRIPTION