ZyXEL Communications MES-2110 - Manual (Page 192)

Chapter 23 Command Line Interface
MES-2110 User’s Guide
192
qos ip-dscp-pri-queue <0~63>
<low|normal|preferred|high>
Sets the QoS IP IP-DSCP Priority to queue
mapping. The default is low.
qos tag-pri-queue <0-7>
<low|normal|preferred|high>
Set the QoS tag priority to queue mapping.
rmon clear
Clears the RMON information for ports 1~10.
snmp contact <contact-name>
Sets the SNMP system contact name.
contact-name
: Enter up to 80 characters.
snmp getcommunity <community-name>
Sets the SNMP GET community.
community-name
: Enter up to 30 characters.
Note: Only for SNMP v2c or lower.
snmp location <location-name>
Sets the SNMP system location.
location-name
: Enter up to 80 characters.
snmp setcommunity <community-name>
Sets the SNMP SET community.
community-name
: Enter up to 30 characters.
Note: Only for SNMP v2c or lower.
snmp trapcommunity <index> <community-
string>
Sets the SNMP trap community.
index
: Enter an index number (1~5).
community-string
: Enter up to 30
characters.
snmp trapenable <index> <enable|disable>
Enables the SNMP trap.
index
: Enter an index number (1~5).
snmp trapip <index> <ip-address>
Sets the IP addresses of up to 5 SNMP
managers to receive SNMP traps.
index
: Enter an index number (1~5).
sntp <enable | disable>
Enables and disables SNTP support.
sntp-NTP-primary-server <ip address>
Set SNTP primary server's IP address.
sntp-NTP-secondary-server <ip address>
Set SNTP secondary server's IP address.
sntp poll_interval <value>
Sets the interval in specified hours between
SNTP requests.
sntp time <yyyy:mo:dd:hh:mm:ss>
Sets the local time by year (yyyy), month (mm),
day (dd), hour (hh), minutes (mm), and
seconds (ss).
sntp timezone <+hh.mm | -hh.mm>
Sets the timezone offset.
+hh.mm
: Increases the timezone offset by the
specified hours (hh) and minutes (mm).
-hh.mm
: Increases the timezone offset by the
specified hours (hh) and minutes (mm).
Table 80 Configuration Mode Commands
COMMAND DESCRIPTION