ZyXEL Communications MES-2110 - Manual (Page 191)

Chapter 23 Command Line Interface
MES-2110 User’s Guide
191
no dhcp smart-relay option
Disables the DHCP smart relay option.
no dhcp smart-relay vlan <cr|range>
Sets the DHCP smart relay to exclude VLANs.
cr
: Leave this field blank and press [Enter] to
use the default setting.
range
: Specify a range of VLAN IDs.
no dhcp snooping enable
Disables DHCP snooping.
no dhcp smart-relay exlude-vlan <1-4094>
Sets the DHCP smart relay to include the
previously excluded specified VLAN.
no dhcp snooping option
Disables the DHCP snooping option.
no dhcp snooping vlan <1-4094>
Disables the specified DHCP snooping VLAN ID.
no dot1x global
Stops 802.1x running globally
no dot1x guest-vlan
Disables Guest VLAN.
no gateway
Sets the device’s default gateway.
no igmp immediate-leave
Sets IGMP fast leave to its default value.
no igmp query-mode <vlan-id>
Sets IGMP query mode to its default type for the
specified VLAN ID.
no igmp snooping
Disables IGMP snooping.
no igmp static
Disables the IGMP static port.
no igmp vlan <1-4094>
Disables IGMP VLAN for the specified VLAN ID.
no ip
Sets the device to its default IP address.
Note: You cannot change the device’s IP
address over Telnet.
no lacp
Disables LACP.
no logins
Resets the login password to NULL.
no mvr <1-4094>
Removes an MVR configuration from the
specified VLAN.
no netmask
Sets the default netmask.
no spanning-tree
Disables the spanning tree.
no trunk <group-id>
Disables the trunk group.
no vlan <2-4094>
Deletes the static VLAN entry.
no vlan-stacking
Disables VLAN stacking.
qinq-sp-tpid <tpid>
Sets the SP TPID. SP TPID is a standard
Ethernet type code identifying the frame and
indicating whether the frame carries IEEE
802.1Q tag information.
tpid
: Enter the Server Provider Tag Protocol
Identifier. This can be a four-digit hexadecimal
number from 0000 to ffff. The default is 9100.
qos schedule all_high_before_low
Sets the QoS schedule to all high before low.
qos schedule weighted_round_robin
Sets the QoS to weighted round_robin.
Table 80 Configuration Mode Commands
COMMAND DESCRIPTION