ZyXEL Communications MES-2110 - Manual (Page 189)

Chapter 23 Command Line Interface
MES-2110 User’s Guide
189
erase-mac-table
Erases all dynamic MAC entries from the MAC
table.
frame-size <1522|1632>
Sets the frame size. The default is 1632.
gateway <ip-address>
Sets the gateway IP address.
hdos ip <index> <ip-address>
Sets the acceptable IP address for Host Denial
of Service (DoS) protection.
index :
Enter an index number (1-5).
ip-address
: Enter an IP address to associate
with an index number.
hdos ip-enable <index> <enable|disable>
Enables or disables an individual IP address for
Host Denial of Service (DoS) protection.
index :
Enter an index number (1-5).
enable|disable
: Enable or disable the IP
address associated with this index number.
hdos protection <enable|disable>
Enables or disables the Host Denial of Service
(DoS) protection service.
igmp immediate-leave <port-list>
Sets the port list for IGMP immediate-leave.
igmp query-mode <auto|disable>
Sets the IGMP query mode.
igmp snooping
Enables IGMP snooping.
igmp static <port-list>
Sets the IGMP static port list.
igmp vlan <1-4094>
Specifies the VLANs on which to perform IGMP
snooping if the mode is fixed.
igmp vlan-mode <auto|fixed>
Specifies how the VLANs snooped by the device
select IGMP packets.
auto
: The device learns multicast group
membership on any VLAN. It drops a.ny IGMP
control messages on other VLANs after it
reaches this maximum number (auto mode).
fixed
: The device only learns multicast group
membership on specified VLAN(s). It drops any
IGMP control messages for any unspecified
VLANs (fixed mode).
igmp vlan-query-mode <vlan-id>
<auto|disable>
Specifies the query mode for the specified VLAN.
ip <ip-address>
Sets the IP address of the device to the one
specified.
lacp group <group> <lacp|static>
Sets the specified trunk group to LACP or static.
lacp hash-mode <xor|lookup>
Sets the hash mode for trunk load balancing
selection.
xor
: Select this XOR the lower 3 bits of the DA
and SA frames together.
lookup
: Select this to use the lookup table.
Table 80 Configuration Mode Commands
COMMAND DESCRIPTION