Chapter 2 basic installation, System requirement, Package content – Z-Com ZMAX-8210-I User Manual

Page 11: Hardware installation, Ystem, Equirement, Ackage, Ontent, Ardware, Nstallation

Advertising
background image

Chapter 2 Basic Installation

System Requirement

Before installing the ZMAX-8210 Customer Premise Equipment, make sure your system meets these

requirements

A PC coupled with 10/ 100Base-TX adapter

Configure the computer with a static IP address of 192.168.1.x (x cannot be 1) and 255.255.255.0

for the Subnet Mask

A Web browser for configuration such as Microsoft Internet Explorer 6.0 or above, or Netscape

Navigator 4.78 or above or Firefox

Package Content

If any missing or damaged, please contact your local seller.

Z-Com ZMAX-8210 Customer Premise Equipment

Power adapter and cord (48V,1A)

Accessories (For its full contents, please refer to accessory installation guide)

ZMAX-8210 Customer Premise Equipment Installation Guide

Hardware Installation

Follow the steps below to install your ZMAX-8210. (the different of hardware installation between

ZMAX-8210-I and ZMAX-8210-E is antenna)

Make sure all components linked to the ZMAX-8210 are on hand.

A brace fixed on the back of the ZMAX-8210 is tabled on a perfect area like well-sized desk.

Attach one end of water-proof cable to a water-proof connector. Alternatively, you can make a

Category 5 UTP straight yourself.

Chapter 2 Introduction - 5 -

Advertising
This manual is related to the following products: