Z-Com ZMAX-8210-I - Manual (Page 19)

devices.
Encryption：This field provides encryption options.
When the communication is established, the encryption shall be completely
identical between the ZMAX-8210 and the Base Station,
IR Bit：This field identifies whether forward “initial ranging data” 。
There shall be in complete accord in the parameters between IR Bit and Base
Station.
Create a Link between the ZMAX-8210 and WiMAX
Base Station
Acting as a customer premise equipment (CPE), the ZMAX-8210 aims at establish a tie with WiMAX
Base Station to enable IP network to be connected to main arteries. We’ll elaborate how to build the
infrastructure via the ZMAX-8210. The CPE has access to connect to the WiMAX Base Station via the
Base Station ID. However, the Duplex Mode, Bandwidth and IR Bit shall conform to the requirements
set when creating a link between the ZMAX-8210 and the Base Station.
Take the following steps to build your infrastructure.
Connect this CPE to PC via a cable. And assign 192.168.1.100 as your PC IP Address.
Basic Settings - 13 -
Figure 11 Build the Infrastructure with WiMAX Base Station
Enter the ZMAX-8210 web-based management. And set proper parameters in the “Base Station
ID”, “Duplex Mode”,“Bandwidth”,“Encryption”and“IR Bit” fields, respectively to establish
a link between your CPE and the WiMAX Base Station.
Note：
Note：
Note：
Chapter 3