Z-Com ZMAX-8210-I - Manual (Page 30)

The file name shall be mercury.cfg.
Restore Factory Default Settings
The ZMAX-8210 provides two ways to restore the default factory settings.
Restore the factory default settings via web:
‚
From the “Restore Factory Default Settings”, clicking “ Restore ” will restore your
ZMAX-8210 default settings.
Restore the factory default settings via “Restore Button”.
‚
When the ZMAX-8210 power adapter is connected to this device, press “Default Button”for
about over10seconds. The“Default Button”is shown as below:
Hardware
Default Button
Figure 24 ZMAX-8210 Default Button
Reboot
The ZMAX-8210 supports PoE supply. You can restore web-based management to reboot this CPE.
Enabling “Yes” can reboot it.
Figure 25 Reboot
SSH
The ZMAX-8210 provides SSH management. It is recommended that Putty is your right option to
access this device’s management.
Open by double clicking Putty
‚
Enter 192.168.1.1 in the “Host Name” field and “Protocol”.
Chapter 5 Management - 24 -