Xantrex Technology 1000 - Manual (Page 39)

Operation
4–4 975-0127-01-01
Inverter Loads
The XPower 1000 will operate most AC loads within its power rating of
1000 watts. However, some appliances and equipment may be difficult to
operate, and other appliances may actually be damaged if you try to
operate them with the XPower 1000. Please read “High Surge Loads” and
“Trouble Loads” carefully.
High Surge Loads
Some induction motors used in freezers, pumps, and other motor-operated
equipment require high surge currents to start. The XPower 1000 may not
be able to start some of these motors even though their rated current draw
is within the inverter’s limits. The XPower 1000 will normally start
single-phase induction motors rated at 1/2 horsepower or less.
Trouble Loads
Some appliances, including the types listed below, may be damaged if
they are connected to the XPower 1000:
• Electronics that modulate RF (radio frequency) signals on the AC line
will not work and may be damaged.
• Speed controllers found in some fans, power tools, kitchen
appliances, and other loads may be damaged.
• Some chargers for small rechargeable batteries can be damaged. See
“Precautions for Using Rechargeable Appliances” on page viii for
details.
• Metal halide arc (HMI) lights can be damaged.
c
CAUTION
Some equipment may be damaged by the XPower 1000’s modified sine wave
output.
Important: If you are unsure about powering any device with the XPower
1000, contact the manufacturer of the device.