2nd Ave. MARMITEK Remote EasyControl4 130405 - Manual (Page 8)

8 MARMITEK - NICOSHOP
4.3 Automatically search for all brands
When you are looking for an unknown code, you can automatically search through all the
codes (AutoSearch).
Note: Because you can assign every device (DVD, satellite) to the VCR, DVD - buttons,
you first have to enter a 3-digit code for the type of device that you want to operate (see
the code book). For example: If you want to program a satellite on the DVD button, you
first have to enter a RANDOM satellite code from the code book and follow the following
steps:
1. Turn the device you want to operate on.
2. Press SETUP (9) and keep this button pressed until one of the mode LEDs stays
lit. Release the SETUP button.
3. Press the Mode button (2) of the device you want to operate. The LED will
flash once.
4. Press Prog+ (6) once. After a few seconds the remote control will begin to
search for the code (quick search, 1 code per second) When the device reacts,
press Prog+ (6) to slow down the search (1 code per 3 seconds). You can go
back with Prog- (6) (or forward with Prog+ (6)) if you went too far. When the
appliance reacts, press -/-- (12) to confirm the code.
Note: If certain functions on your appliance do npt work, try the next code for your
brand. The search function will begin after the last confirmed code. If that was 030, the
search function will begin at 031, and will continue until the last possible code.
4.4 Manually searching for codes
Note: Because you can assign every device (DVD, satellite) to the VCR, DVD, AUDIO, SAT
buttons, you first have to enter a 3-digit code for the type of device you want to operate
(see the code book). For example: If you want to program a satellite on the DVD button,
you first have to enter a RANDOM satellite code from the code book and follow the fol-
lowing steps:
1. Turn the device you want to operate on.
2. Press SETUP (9) and keep this button pressed until one of the mode LEDs stays
lit. Release the SETUP button.
3. Press the Mode button (2) of the device you want to operate and then release
it.
4. Press the Prog+ (6) until it changes channel. If you went past the correct code,
use Prog- (6) to go back to the correct code.
5. Press -/-- (12) when the device reacts to confirm the code.
Note: If your appliance does not have Prog+ button, you can use the PLAY (video or DVD)
(20) or On/Off button (1).
Note: If certain functions on your device do not work, you have to try the next code for
your brand. The search function will begin after the last confirmed code. If that was 030,
the search function will begin at 031, and will continue until the last possible code.