3Com V7111 - Manual (Page 15)

Figure 3 View of the V7111 Base
2 3
1
Table 2 View of the V7111 Base
Item # Functionality
1 Square slot used to attach anti-slide bumpers (for desktop mounting)
2 Oval notch used to attach the V7111 to a wall
3 Screw opening used to attach the V7111 to a 19-inch shelf rack
Mounting the V7111 on a Desktop
Attach the four (supplied) anti-slide bumpers to the base of the V7111 (see item #1 in Figure
3 ) and place it on the desktop in the position you require.
Mounting the V7111 on a Wall
To mount the V7111 on a wall, follow these 4 steps:
1 Drill four holes according to the following dimensions:
ƒ Side-to-side distance 140 mm.
ƒ Front-to-back distance 101.4 mm.
2 Insert a wall anchor of the appropriate size into each hole.
3 Fasten a DIN 96 3.5X20 wood screw (not supplied) into each of the wall anchors.
4 Position the four oval notches located on the base of the V7111 (see item #2 in Figure 3 )
over the four screws and hang the V7111 on them.
3Com VCX V7111 Analog Gateway Installation Guide 15