3Com V7111 - Manual (Page 32)

4 Click OK; the ‘Quick Setup’ screen is accessed, shown in Figure 19 (MGCP), Figure 20
(H.323), and Figure 21 (SIP).
Basic Control Protocol Parameters
To configure the V7111 basic control protocol parameters use the Embedded Web Server’s
‘Quick Setup’ screen.
ƒ For MGCP, see Configuring Basic MGCP Parameters .
ƒ For H.323, see Configuring Basic H.323 Parameters .
ƒ For SIP, see Configuring Basic SIP Parameters .
When you have completed the above relevant section you are then ready to start using the
V7111. For information on how to fully configure the VoIP gateway, refer to the V7111 User’s
Manuals.
Once the gateway is configured correctly, back up your settings by making a copy
of the VoIP gateway configuration (
ini file) and store it in a directory on your PC.
This saved file can be used to restore configuration settings at a future time. For
information on backing up and restoring the gateway’s configuration, see
Chapter
5: Restoring and Backing Up the V7111 Configuration .
Configuring Basic The following configuring Sections from here up to and including
SIP Parameters apply individually to MGCP, H.323, or SIP.
MGCP configuring continues with Configuring Basic MGCP Parameters .
H.323 configuring continues with Configuring Basic H.323 Parameters .
SIP configuring continues with Configuring Basic SIP Parameters .
Configuring Basic MGCP Parameters
Accessing the Embedded Web Server After accessing the Embedded Web Server (see ) the
MGCP ‘Quick Setup’ screen is displayed, shown in Figure 19 .
32 3Com VCX V7111 Analog Gateway Installation Guide