3Com WL-603 - Manual (Page 121)

VPN 119
Figure 96 Add New VPN Tunnel Configuration Screen
On the VPN Tunnel Parameter screen,
1 Set the VPN Tunnel Type to IPSec.
2 Enter a descriptive name for the tunnel in the Tunnel Name field.
3 Remote VPN Gateway - select IP address, and then enter the IP address in
the IP Address/Host Name field. If you select ANY, then it would be no
need to enter the IP address, as any remote server can be used.
4 At the Remote Party ID drop-down list, select either IP_IPV4_ADDR or
ID_USER_FQDN. This information must be entered identically on the IPSec
software installed on the client’s machine.
If IP_IPV4_ADDR is selected, then enter the IP address and subnet mask in
the Remote Network Address, and Remote Subnet Mask fields. The
remote network address is usually the network address of the LAN
connected to the remote server.
If ID_USER_FQDN is selected, then enter the name for the Remote Party
ID in the text box area next to the drop-down menu. This name must be
unique for each connection rule that you create. Enter the IP address and
subnet mask in the Remote Network Address, and Remote Subnet Mask
fields.
Note that if you select IKE Main Mode from the Key Management
drop-down menu (see step 6), you must enter IP_IPV4_ADDR here.