3Com WL-603 - Manual (Page 86)

84 C HAPTER 5: C ONFIGURING THE R OUTER
Routing Mode over ATM
RFC1483/2684 routed encapsulation in routing mode, it carries IP
datagrams directly over ATM. DHCP client function can also be enabled
to obtain an IP address dynamically.
Figure 64 Routing Mode over ATM Screen
1 Select Routing mode over ATM from the protocol drop-down menu.
2 Enter IP address, Subnet mask, and Default gateway information.
3 If your ISP provides DNS information, check the DNS Automatic from ISP
box.
4 If the ISP requires you to input a Host Name, enter it in the Host Name
field.
5 If your ISP uses DHCP to automatically assign IP addresses, check the
DHCP Client checkbox.
6 Check the Add Default Route checkbox to set this PVC as the default
route, this is used when you configure more than one PVC for the Router.
7 Enter the VPI/VCI values. Or click Auto Search to find out the values.
8 Select the Encapsulation, VC MUX or LLC. This information should be
provided by your ISP.