3Com WL-603 - Manual (Page 24)

22 C HAPTER 2: I NSTALLING THE R OUTER
When positioning your Router, ensure:
■
It is out of direct sunlight and away from sources of heat.
■
Cabling is away from power lines, fluorescent lighting fixtures, and
sources of electrical noise such as radios, transmitters and broadband
amplifiers.
■ Water or moisture cannot enter the case of the unit.
■ Air flow around the unit and through the vents in the side of the case
is not restricted. 3Com recommends you provide a minimum of
25 mm (1 in.) clearance.
Using the Rubber
Feet
Use the four self-adhesive rubber feet to prevent your Router from
moving around on your desk or when stacking with flat top units. Only
stick the feet to the marked areas at each corner of the underside of your
Router.
Please be careful when you put 3Com 11n ADSL Router on top of
another unit, if the unit underneath is hot, this may impact the reliability
of 3Com 11n ADSL Router.
Wall Mounting There are two slots on the underside of the Router that can be used for
wall mounting. The Router must be mounted with the LEDs facing
upwards.
When wall mounting the unit, ensure it is within reach of the power
outlet. When wall mounting the unit, ensure that the rubber feet are not
fixed.
Mounting
Instructions for
Cement Walls
To wall mount the unit:
1 Make two holes 98 mm (3.9 in.) apart and insert two nylon or similar
screw anchors that are suitable for the wall construction.
2 Fix two suitable screws into the anchors, leaving their heads 3 mm (0.12
in.) clear of the wall surface. The screws should be at least 30 mm (1.2
in.) long.
3 Remove any connections in the Router and locate it over the screw heads.
When in line, gently push the Router on to the wall and move it
downwards to secure.