3Com WL-603 - Manual (Page 124)

122 C HAPTER 5: C ONFIGURING THE R OUTER
1 Set the Tunnel Type to L2TP over IPSec.
2 Enter a descriptive name for the tunnel in the Tunnel Name field.
3 Enter the User name and Password.
4 Enter the Idle Timeout value.
5 Set the L2TP Type Setting to L2TP Server, or L2TP Client.
■
if you set the type as L2TP Client, then set the Local Type Setting to
Network or Host, then enter the Remote Server IP. Check the Auto
reconnect box, if you want to auto-reconnect after disconnection.
■
if the L2TP Type Setting is set to L2TP Server, go to step 6.
6 Check the box to enable the Remote Network Setting, and then enter the
Remote Network Address, and Remote Subnet Mask information.
7 When the L2TP Type Setting is set to L2TP Client, you would then need to
enter the Pre-shared Key information.
8 Click Apply.
Check the Enable PPTP box, configuration details screen appears,
see
Figure 99 .
Figure 99 Enable PPTP Screen
1 Define the IP Address Pool for PPTP clients, enter the start/end address.
2 Click Add to create a new entry, see Figure 100 .