Edimax Technology BR-6215SRg - Manual (Page 38)

37
Parameters Description
Enable wireless access
control
Enable wireless access control
Add MAC address into the
list
Fill in the "MAC Address" and "Comment" of the wireless station to be added and then click
"Add". Then this wireless station will be added into the "Current Access Control List" below.
If you find any issues before adding it and want to retype again. Just click "Clear" and both
"MAC Address" and "Comment" fields will be cleared.
Remove MAC address
from list
If you want to remove some MAC address from the "Current Access Control List ", select
the MAC addresses you want to remove in the list and then click "Delete Selected". If you
want remove all MAC addresses from the table, just click "Delete All" button. Click "Reset"
will clear your current selections.
Click <Apply> at the bottom of the screen to save the above configurations. You can now configure other advance
sections or start using the router (with the advance settings in place)
2.5 QoS
The QoS can let you classify Internet application traffic by source/destination IP address and port number. You can
assign priority for each type of application and reserve bandwidth for it. The packets of applications with higher priority
will always go first. Lower priority applications will get bandwidth after higher priority applications get enough bandwidth.
This can let you have a better experience in using critical real time services like Internet phone, video conference …etc.
All the applications not specified by you are classified as rule name “Others”. The rule with smaller priority number has
higher priority; the rule with larger priority number has lower priority. You can adjust the priority of the rules by moving
them up or down.
Note: If the total assigned bandwidth of higher priority applications is larger than the maximum bandwidth provided by the
WAN port, the other applications will not get any bandwidth.