Edimax Technology BR-6215SRg - Manual (Page 39)

38
Parameters Description
Enable/Disable QoS
You can check “Enable QoS” to enable QoS function for the WAN port. You also can
uncheck “Enable QoS” to disable QoS function for the WAN port.
Total Download
Bandwidth
Here you can set maximum download bandwidth for all the users of the router sharing.
Total Upload Bandwidth Here you can set the maximum upload bandwidth for all the users of the router sharing.
Add a QoS rule into the
table
Click “Add” then you will enter a form of the QoS rule. Click “Apply” after filling out the form
and the rule will be added into the table.
Remove QoS rules from
table
If you want to remove some QoS rules from the table, select the QoS rules you want to
remove in the table and then click "Delete Selected". If you want remove all QoS rules from
the table, just click "Delete All" button. Click "Reset" will clear your current selections.
Edit a QoS rule
Select the rule you want to edit and click “Edit”, then you will enter the detail form of the
QoS rule. Click “Apply” after editing the form and the rule will be saved.
Adjust QoS rule priority
You can select the rule and click “Move Up” to make its priority higher. You also can select
the rule and click “Move Down” to make its priority lower.
Edit QoS Rule:
You can assign packet classification criteria by its local IP range, remote IP range, traffic type, protocol, local port range
and remote port range parameters. The parameters that you leave as blank will be ignored. The priority of this rule will be
applied to packets that match classification criteria of this rule. You can limit bandwidth consumed by packets that match
this rule or guarantee bandwidth required by packets that match this rule.