STIEBEL ELTRON PSH Universal EL с 05.12.2011 - Manual (Page 23)

oPeration
SettingS
En
gl
ish
www.Stiebel-eltron.CoM PSH UniverSal el| 23
4.2 Factory settings
After commissioning, the set temperature is set to the maximum
value of 85 °C. Symbols indicate that the appliance has heated
up the water and ECO Comfort energy saving mode is selected.
1
2 3
1
2 3
26
�0
2�
07
�0
29
0
1 Set temperature display (factory setting 85 °C)
2 Heat-up symbol
3 ECO Comfort energy saving mode symbol (factory setting)
4.3 Button functions
4.3.1 set temperature and frost protection settings
The current set temperature is displayed.
Factory setting: 85 °C
f f Use the plus and minus buttons to
adjust the set temperature from 20 to
85 °C or select the frost protection set-
ting at 7 °C.
As soon as the water temperature drops
below the selected value, the heating ele-
ment automatically switches on. The heat-
up symbol is displayed until the tempera-
ture reaches the selected set temperature
again.
7
When 7 °C is selected, frost protection is
switched on automatically and the frost
protection symbol appears.
Note
If you change the set temperature, the appliance switches
automatically to ECO Comfort energy saving mode.
For low water consumption or very hard water, we recommend
a low set temperature, as water above approx. 55 °C deposits
limescale.
Holiday and absence
f f If the appliance is not in use for long periods, select 7 °C as
the set temperature (frost protection) or disconnect the appli-
ance from the power supply in order to save energy.
f f For reasons of hygiene, heat up the content of the water
heater once to above 60 °C before initial use.
4.3.2 switching rapid heating on/off
With rapid heating, the appliance heats the water content up to
maximum temperature. If you have switched on a temperature
limit, the selected temperature limit is also the maximum value
for the set temperature. Once the maximum temperature has been
reached, the rapid heating function is switched off automatically.
In standard mode, the previously selected set temperature is ena-
bled again.
f f To switch on, press the rapid heating
button.
The rapid heating symbol appears.
f f To switch off, press the rapid heating
button again.
The rapid heating symbol goes out.