HONDA 2010 Insight - Manual (Page 353)

Changing the oil and filter requires
special tools and access from
underneath the vehicle. The vehicle
should be raised on a service station-
type hydraulic lift for this service.
Unless you have the knowledge and
proper equipment, you should have
this maintenance done by a skilled
mechanic.
Run the engine until it reaches
normal operating temperature,
then shut it off.
Open the hood, and remove the
engine oil fill cap.
Remove the screws with a Phillips-
head screwdriver, and clips with a
flat-tipped screwdriver, then pull
the under-cover down.
Always change the oil and filter
according to the maintenance
messages shown on the multi-
information display. The oil and filter
collect contaminants that can
damage your engine if they are not
removed regularly.
1.
2.
3.
Changing the Oil and Filter
350
SCREW
CLIP
SCREWS
2010 Insight