Lights, 2010 insight – HONDA 2010 Insight User Manual
Page 369
Advertising
Remove the two mounting bolts
with an 8 mm wrench.
Pull the rear of the light assembly
out as shown in the illustration
above (
), then push the
assembly back to the original
position carefully (
). The front
part of the rear light assembly
raises slightly (
).
Determine which of the three
bulbs is burned out: back-up light,
turn signal, or side marker.
Pull the whole light assembly
outwards from the body carefully.
Remove the socket by turning it
one-quarter turn counterclockwise.
Remove the burned out bulb by
pulling it straight out of its socket.
6.
7.
5.
8.
9.
10.
Lights
366
BOLT
ORIGINAL
POSITION
Front
Front
Left side
BULB
SOCKET
SNAP FASTENERS
Left side
2010 Insight
Advertising
This manual is related to the following products: