HONDA 2010 Odyssey - Manual (Page 104)

With the ignition switch in the ON
(II) position, press and hold the
INFO button for more than 3
seconds. ‘‘CUSTOMIZE ENTRY’’
appears on the multi-information
display.
You can customize some vehicle
control settings for ‘‘DRIVER 1’’ and
‘‘DRIVER 2’’ separately.
To have the driver’s ID detected,
make sure you use your transmitter
to unlock the driver’s door.
If you use the key to unlock the
driver’s door, the system cannot
recognize either ‘‘DRIVER 1’’ or
‘‘DRIVER 2.’’ In this case, when you
try to enter the customizing mode,
‘‘DRIVER UNKNOWN
CUSTOMIZE IMPOSSIBLE’’ will be
displayed, and you cannot customize
the settings.
Refer to the table on the following
pages about the settings you want to
customize.
Use the INFO button on the steering
wheel to see the settings, and the
SEL/RESET button to enter your
selections.
If you want the settings as they were
when the vehicle left the factory,
select ‘‘DEFAULT ALL,’’ as
described on page
.
If you want to change any vehicle
control settings, select ‘‘CHANGE
SETTING,’’ and follow the
instructions on page
.
The first customizing menu is:
CHANGE SETTING
DEFAULT ALL
You cannot customize the settings
under these conditions:
If you turn the ignition switch to
the ACCESSORY (I) or the LOCK
(0) position.
If you move the shift lever out of
Park.
You can cancel each custom setting
(Driver 1, Driver 2). Press and hold
the LOCK and SLIDING DOOR
button (passenger’s side) at the
same time until the LED in the
remote transmitter blinks twice. At
this time, the custom setting is
changed to the default setting. To
activate each custom setting (Driver
1, Driver 2), repeat this procedure.
The LED will blink for 1 second to
indicate the custom setting has been
activated.
106
104
CONTINUED
Customized Settings
Multi-Information Display
Inst
ru
m
e
nt
s
a
nd
Cont
ro
ls
101
2010 Odyssey