Automatic transmission – HONDA 2010 Odyssey User Manual

Page 391

Advertising
background image

If you exceed the maximum speed
for the gear you are in, the engine
speed will enter into the tachometer’s
red zone. If this occurs, you may feel
the engine cut in and out. This is
caused by a limiter in the engine’s
computer controls. The engine will
run normally when you reduce the
rpm below the red zone.

This position locks

the transmission in second gear. It
does not downshift to first gear
when you come to a stop.

Use second gear:

For more power when climbing.
To increase engine braking when
going down steep hills.
For starting out on a slippery
surface or in deep snow.
When driving downhill with a
trailer.

Use this position for

normal driving. The transmission
automatically selects a suitable gear
for your speed and acceleration.

To use D , press the

D button when the shift lever is in
the ‘‘D’’ position. This position is simi-
lar to D, except only the first three
gears are selected instead of all five.
Use D when towing a trailer in hilly
terrain, or to provide engine braking
when going down a steep hill. D can
also keep the transmission from
cycling between third and fourth
gears in stop-and-go driving.

To shift from second to

first, press the release button on the
side of the shift lever. This position
locks the transmission in first gear.
By upshifting and downshifting
through 1, 2, D , and D, you can
operate the transmission much like a
manual transmission without a
clutch pedal.

3

3

3

3

3

Automatic Transmission

Engine Speed Limiter

Second (2)

Drive (D)

Drive (D )

First (1)

3

388

2010 Odyssey

Advertising
This manual is related to the following products: