Tire pressure monitoring system (tpms) – HONDA 2010 Ridgeline User Manual

Page 286

Advertising
background image

Although your tire pressure is
monitored, you must manually check
the tire pressures monthly.

Each tire, including the spare, should
be checked monthly when the
vehicle is cold, and set to the
recommended inflation pressure as
specified on the vehicle placard and
in the owner’s manual (see page

).

To select the tire pressure monitor,
press the INFO button several times
with the ignition switch in the ON
(II) position.

You will see the above display on the
multi-information display when all
tire pressures are normal.

For example, if you check and fill
your tires in a warm area, then drive
in extremely cold weather, the tire
pressure will be lower than
measured and could be underinflated
and cause the low tire pressure/
TPMS indicator to come on. Or, if
you check and adjust your tire
pressure in cooler conditions, and
drive into extremely hot conditions,
the tire may become overinflated.
However, the low tire pressure/
TPMS indicator will not come on if
the tires are overinflated.

Refer to page

for tire inflation

guidelines.

If there is a problem with the TPMS,
this indicator begins to flash. It stops
flashing after approximately 1
minute, then stays on. You will also
see a ‘‘CHECK TPMS SYSTEM’’
message on the multi-information
display (see page

).

350

349

91

Tire Pressure Monitor

Tire Pressure Monitoring System (TPMS)

282

09/07/18 14:48:21 31SJC640_287

2010 Ridgeline

Advertising
This manual is related to the following products: