Instrument panel indicators – HONDA 2010 Ridgeline User Manual
Page 70
This indicator normally comes on for
a few seconds when you turn the
ignition switch to the ON (II)
position, and when the ignition
switch is turned to the START (III)
position. If it comes on at any other
time, there is a problem with the
ABS. If this happens, have your
vehicle checked at a dealer. With the
indicator on, your vehicle still has
normal braking ability but no anti-
lock brakes. For more information,
see page
.
This indicator comes on for a few
seconds when you turn the ignition
switch to the ON (II) position. It will
go off if you have inserted a properly
coded ignition key. If it is not a
properly coded key, the indicator will
blink and the engine will not start
(see page
).
This indicator also blinks several
times when you turn the ignition
switch from the ON (II) position to
the ACCESSORY (I) or LOCK (0)
position.
You will also see a ‘‘CHECK ABS
SYSTEM’’ message on the multi-
information display (see page
).
The left or right turn signal indicator
blinks when you signal a lane change
or turn. If an indicator does not blink
or blinks rapidly, it usually means
one of the turn signal bulbs is
burned out (see pages
and
).
Replace the bulb as soon as possible,
since other drivers cannot see that
you are signaling.
When you press the hazard warning
button, both turn signal indicators
and all turn signals on the outside of
the vehicle flash.
On models with navigation system
Anti-lock Brake System
(ABS) Indicator
Immobilizer System
Indicator
Turn Signal and
Hazard Warning
Indicators
Instrument Panel Indicators
66
09/07/18 14:08:47 31SJC640_071
2010 Ridgeline