HONDA 2011 CR-Z - Manual (Page 122)

121
Controls
Adjusting the Seats Adjusting the Seat Position
Head Restraints ■
Your vehicle is equipped with head restraints in both seating positions. However,
they are non-adjustable.
Head restraints are effective for protection against whiplash and other rear-impact
crash injuries.
Removing and Installing the Head Restraint for Cleaning ■
To remove the head restraint:
1. Unhook the strap on the outside edge of
the seat-back.
Pull out the strap throughout the band
2.
on the outside under edge of the head
restraint.
Push the release button, and pull the head
3.
restraint upward.
To install the head restraint:
1. Put the legs back in place, then slightly
lower it.
Do not push it down fully until it locks
in place.
Insert the strap onto the band, then hook 2.
it to the magnet on the outside edge of
the seat-back.
Push the head restraint down until it locks.
3.
Make sure the head restraint locks in place
when you reinstall it.
Head Restraints
The driver’s and passenger’s seats have active head
restraints.
WARNING
Failure to reinstall the head restraints
can result in severe injury during a
crash.
Always replace the head restraints
before driving.
Band
Strap
Release Button
Magnet
31SZT600book.indb 121 2010/04/28 13:41:58
2011 CR-Z