Pc 5153, B. digital i/o interface, B.1 introduction – Acnodes PC 5153 User Manual
Page 91: B.2 dio connector pinouts, B.3 assembly language samples
14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at .
PC 5153
15” Industrial wireless Panel PC
B. DIGITAL I/O INTERFACE
B.1 INTRODUCTION
The DIO connector on the PC5153/ PC5173 is interfaced to GPIO ports on the Super I/O chipset. The
DIO has both 4-bit digital inputs and 4-bit digital outputs. The digital inputs and digital outputs are
generally control signals that control the on/off circuit of external devices or TTL devices. Data can be
read or written to the selected address to enable the DIO functions.
NOTE:
For further information, please refer to the datasheet for the Super I/O chipset.
B.2 DIO CONNECTOR PINOUTS
The following table describes how the DIO connector pins are connected to the Super I/O.
B.3 ASSEMBLY LANGUAGE SAMPLES
B.3.1 ENABLE THE DIO INPUT FUNCTION
The BIOS interrupt call INT 15H controls the digital I/O. An assembly program to enable digital I/O input
functions is listed below.
MOV AX, 6F08H Sets the digital port as input
INT
15H Initiates the INT 15H BIOS call