Acroprint timeQplus Biometric (V2) TQ100 Terminal - Manual (Page 13)

timeQplus BIOMETRIC™ Terminal User Manual 13 32 timeQplus BIOMETRIC™ Terminal User Manual
4.2.3 Network Connection using Ethernet communication
function with RJ45 interface
A) In Communication Setting, press Scroll-down to set RS485
communication to “No” and set Ethernet to “Yes”, displayed as follows:
B) Set the IP address, subnet mask and default gateway to those of
the LAN. The IP address must be unique. The same password must
be used both in the terminal setup and PC software.
C) Turn the terminal off.
D) Connect the network cable of the LAN to the RJ45 interface
of the terminal.
E) Turn on the terminal.
Setting Items Explanation
No
1 - 1500
Factory Setting
Indicates that the terminal will not give out alert when
punches stored on the terminal are overflowed. If the
total punches surpass the maximum storage capacity,
then the terminal will not store any new punches. The
maximum storage capacity is 30,000 punches.
The terminal will inform that the records are
overflowed according to the value set. If the value
is 1000, then the alert will be given out from
the 29,000th record.
1000
Note: The user is prompted through the message on the display that the
punch storage space is reaching maximum capacity. Once the alert is given out,
download the records as soon as possible.
Setting Items Explanation
No
1 - 255
Factory Setting No
3. Punch Interval (duplicate punches)
Indicates the terminal will record all punches,
including duplicate punches.
Indicates the terminal will disregard duplicate punches
for subsequent punches received within the period of
time that has been set up. The unit of measure is one
minute.
Note: If the user punches the terminal repeatedly within the set up interval
defined, no duplicate records will be stored.
2. Total Punches Alert
Communication
Default gateway
RS485
Ethernet
No
Yes
Note: A 6 ft Ethernet cable
is included in the standard
package.