Acroprint timeQplus Biometric (V2) TQ100 Terminal - Manual (Page 5)

timeQplus BIOMETRIC™ Terminal User Manual 5 40 timeQplus BIOMETRIC™ Terminal User Manual
Chapter Two: Hardware Setup
2.1 Terminal Installation
To power up the TQ100 biometric terminal:
A) Unwrap the package and take out the terminal and accessories.
B) Using the screws supplied, fasten the mounting plate on the wall in an
appropriate place. Avoid areas with strong magnetic and/or electric fields.
C) Attach the terminal to the mounting plate.
D) Plug in the power supply and turn the terminal on (Press button).
2.2 Keyboard image and functions
Keypad configuration is presented in Figure 2.1:
Figure 2.1
The keypad functionality is described below
1 2 3 ESC
4 5 6 ▲
7 8 9 ▼
•
0 OK MENU
To perform EXIT, CANCEL, IGNORE when using the menu
To access the Menu structure
To confirm and save the selection
Power switch
Scroll-up button for menu operations
Scroll-down button for menu operations
Keys to use when operating or performing system
setup or entering User ID or password
MENU
OK
0 - 9
RS485
Wiring Diagram
Junction Box
Terminal 2
Junction Box
Terminal 1
PC
To Terminals 3 - 32
To Terminal 2
To Terminal 1
(short as possible)
Teflon Cable
Junction
Box
RJ11 Cable
To serial port
on host computer
Attach an RJ11 connector to the Cat5 cable
terminated with an RJ45 connector and supplied
with the standard package. Looking at the RJ11
connector pictured above the Brown wire goes to
the leftmost PIN and the Brown/White wire
goes to the rightmost PIN.
RS232/RS485
Converter
ESC