Acroprint timeQplus Biometric (V2) TQ100 Terminal - Manual (Page 26)

timeQplus BIOMETRIC™ Terminal User Manual 19 26 timeQplus BIOMETRIC™ Terminal User Manual
It is recommended to perform a fingerprint check to confirm its
validity. If it validates, it means that your enrolled fingerprint is
of good quality and the message in Figure B below is displayed.
If the fingerprint fails, the enrolled fingerprint is not clear and
validation errors are likely to occur in the future, see Figure C;
in this case enrollment should be redone and/or a different
finger used.
Next the screen is displayed and a new enrollment cycle begins
as shown below.
Press OK to continue enrolling new users; press ESC to enroll
backup (multiple) fingerprints for a user (Fig D)
If you want to enroll fingerprint backups for existing users, enter
the user ID number of the employee you want to add fingerprint
backups for. For password registration, an explanation will be
given in “Chapter Seven: Administrator Functions,” 7.1.1
and 7.1.2.
Finger
FP Check OK
Finger
FP Check NG
Figure B Figure C
Finger
New Enroll?
No - ESC Yes - OK
Backup
ID 00001
ESC Set - OK
Figure D
7.1.4 Select Delete Registration Data menu and press OK to access
the level-3 menu as follows:
Input the User ID to be deleted, e.g. number 00001, and then press OK
to display the following:
Press OK to confirm:
Press OK to delete. A “click” sound will be sent out with a prompt of
“Enroll Empty.” Then it will return to the delete user interface as below;
press ESC to cancel and exit.
Delete
ID 00000
Delete
ID 00001-1
Note: the last
digit indicates
the first fingerprint.
Delete
Delete?
No-ESC Yes-OK
Delete
Continue?
No-ESC Yes-OK