Actron AutoScanner® Plus CP9580A - Manual (Page 90)

Diagnostic Menu
4 – 34 • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • • •
4 4
✓
Non-CAN Vehicles
=====================
ID
01
MOd $10
MAX 80
MEAS
00
MIN ----
Test $01
STS OK
On Non-CAN vehicles the Scan
Tool displays:
❒ Test data (test ID)
❒ Maximum value (MAX)
❒ Test measurements (MEAS)
❒ Minimum value (MIN)
❒ Status (STS)
❒ Measurements and
Specification values are
hexadecimal numbers (i.e.,
$1A, $FE, $11.)
❒ Module (MOD)
OR
✓
CAN Vehicles
=====================
RICH-LN
Thresh
Module $00
MAX: 0.6012 (V)
MEAS: 0.6012 (V)
MIN: 0.6012 (V)
O2 Sensor B2S2
On CAN vehicles Scan Tool
displays:
❒ Test performed. The test
performed can be $## if test is
not defined. Refer to vehicle
service manual for details.
❒ Measured values and units of
measured (such as volts,
amps, and seconds).
❒ Status of monitor test data.
❒ Module ID where the monitor
test data came from.
3. Return to Select Test Menu.
•Press BACK key.
4. Return to Diagnostic Menu.
•Press BACK key.