Garmin GPS 400 - Manual (Page 67)

GPS 400 Pilot’s Guide and Reference 190-00140-60 Rev. H 4-7
SECTION 4
FLIGHT PLANS
Crossfilling flight plans between two
400/500-Series Garmin units:
1) Select the ‘Crossfill?’ option from the Flight
Plan Catalog Page Menu (Figure 4-13) and
press the ENT Key.
Figure 4-13 Flight Plan Catalog Page Menu
2) Turn the large right knob to select the
‘Method’ field (Figure 4-14).
Figure 4-14 Crossfill Page
3) Turn the small right knob to select ‘Auto’
or ‘Manual’ and press the ENT Key. ‘Auto’
automatically transfers the active flight plan or
Direct-to selection to another 400/500-series
Garmin unit, without user intervention.
4) If ‘Manual’ is selected: Turn the large right
knob to select the ‘Transfer’ field, then turn
the small right knob to select the type of
information to transfer between units (active
flight plan, flight plan, all user waypoints or
a single user waypoint). When ‘Flight Plan’
or ‘User Waypoint’ is selected, a second field
appears to the immediate right of the ‘Transfer’
field. Use the small and large right knobs to
enter the number of the flight plan or the name
of the user waypoint to be transferred.
5) The ‘Cross-side’ field allows the pilot to
designate the sending and receiving units
in a crossfill operation. Turn the large right
knob to select the ‘Cross-side’ field, then turn
the small right knob to select ‘To’ or ‘From’
(Figure 4-15). Press the ENT Key to confirm
the selection.
Figure 4-15 Transfer Window
6) Turn the large right knob to highlight ‘Initiate
Transfer?’ and press the ENT Key.